Car Door Edge Guards 32Ft(10M) U Shape Rubber Seal Protector

Introducing our Car Door Edge Guards. These guards are designed to prevent dust, rain, air, and noise from entering your vehicle while also improving air conditioning efficiency and mitigating vibrations. They are carefully crafted to cover various edges of the vehicle, including the luggage compartment lid, hood, doors, and grille, to prevent and protect against debris and scratches that can lead to rust over time.

To install the door edge guards, follow these simple steps: 1. Clean the door edge to remove any oil, wax, and dust. Ensure the door is dry before proceeding. 2. Peel off the tape from the lining and remove the red strip from the tape by approximately 2 inches. 3. Starting from the top, insert the lining onto the door edge until it is fully seated. 4. Press the lining along the door edge with your thumb until fully seated, then remove the red strip. Repeat for all edges. 5. Trim any excess lining with scissors for other door edges. 6. Allow the lining to dry for at least 12 hours without getting wet.

These door edge guards are easy to install with no tools required. The U channel design fits easily over any door edge for optimal protection. They work best for door edge thickness up to 5 mm (0.2"). Truck and van owners should verify their door edge thickness before purchasing.

Protect your vehicle's door edges with these guards to prevent nicks, chips, scratches, door dings, dents, chipping paint, and rust. This simple solution helps maintain your vehicle's condition without the need for full paint protection.

Using sticky double-sided adhesive tape, the guards securely attach to the door edge (using primer is recommended). The adhesive should be placed on the inside of the door edge for a seamless look. Installation and removal are convenient for any DIY enthusiast, taking less than 20 minutes.

Take care of your car by installing these door edge guards and enjoy a literal line of defense against unwanted damage. Preserve the integrity of your vehicle's paint and metal with this invisible protection.

Please note that if the adhesive does not stick firmly, clean the area with a damp towel and let it air dry before reapplying. Press lightly during application to ensure a snug fit, and avoid getting the guards wet for 24 hours after installation.

product information: